About ScanWorks
ScanWorks® tools validate, characterize and test chips and circuit boards in development, manufacturing and field service. Structural integrity tests can be re-used over the product’s life cycle. Statistical analysis and data mining of operating margins validates a design’s probable performance. Learn more about the value of Hardware Validation, Chip Debug and Manufacturing Test.
ScanWorks Boundary-Scan Test
Excellent and high-resolution coverage of structural faults. The ScanWorks platform’s boundary-scan/JTAG tools locate defects on individual pins and programs devices quickly.
ScanWorks Fast Flash Programming
Growth in flash programs slowing your production down? ScanWorks has the Fast Flash in-system programming answers to get your products flying down the line.
ScanWorks Embedded Diagnostics
Embedding ScanWorks in-system pays off in a big way. Data leading up to a failure is stored so forensics can find root causes fast. And it works locally or remotely through the cloud.
ScanWorks FPGA-based Fast Programming
Allows for IP to be inserted into an FPGA to dramatically speed up in-system device programming versus what can be accomplished with normal boundary-scan programming.
ScanWorks DDR Tuning, Calibration & Test
Saving time and optimizing performance are constantly concerns. ScanWorks’ DDR tuning solution addresses both concerns with unique SoC specific downloadable IP.
ScanWorks Board Functional Test & Device Programming
Increase your board test coverage by executing at-speed bus tests of the I/O and memory busses and get structural coverage where other tests may leave gaps.
ScanWorks IJTAG Test
Increase your board test coverage by executing at-speed bus tests of the I/O and memory busses with ScanWorks Processor-based Functional Test products. Additionally, get structural coverage where other tests may leave gaps.
ScanWorks FPGA-Controlled Test
The ScanWorks FPGA-Controlled Test (FCT) product allows for IP to be inserted into an FPGA that is already part of the design to perform validation of buses, functional testing and other tests complementing your boundary scan tests for improved test coverage.
Hardware for ScanWorks
The ScanWorks platform for embedded instruments is supported by a wide variety of hardware controllers and accessories with which engineers can connect ScanWorks to their unit under test (UUT). Hardware is available for development, production and repair environments. The test platform required for ScanWorks is either a standard PC or a system with a built-in (embedded) JTAG controller.
